Reset ErrorCount

ErrorCount parameters keep increasing as new errors are encountered. When no error occurs, the ErrorCount parameter remains at zero. When one error occurs, the ErrorCount parameter is increased to 1 (one), and retains this value until it is acknowledged by an operator. When another error occurs, the ErrorCount parameter is increased to 2 (two), and again, it retains this value until it is acknowledged by an operator.

To reset the ErrorCount parameter of a specific device, an operator must manually activate the Acknowledge ErrorCount Alert and Reset command via the console menu (right-click the NetApp filer icon> KM Commands > KM Settings >  Acknowledge ErrorCount Alert and Reset).This mechanism makes sure that an operator of an administrator is aware of the encountered error.

However, since the manual acknowledgment of each error can rapidly become time consuming, NetApp Filers KM for PATROL can be configured to automatically acknowledge an alert on the ErrorCount parameter and reset it to zero after a specified period of time.

•To set the automatic ErrorCount parameter reset for a specific device, right-click the NetApp Filers icon > KM Commands > KM Settings > Automatic ErrorCount Reset:

Automatic ErrorCount Reset

Select the period of time after which you want the KM to automatically reset the ErrorCount parameter and click OK.

In many cases, an error that do not reoccur after a certain amount of time can be safely ignored. Automatically resetting ErrorCount parameters to zero after a few hours is often considered as a good practice.