Description

Gives physical disk and array status.

Target

Typical platform: Any system with LSI sas2ircu

Operating system: Linux

Prerequisites

Relies on: Sas2Ircu (LSI) managed RAID card

Technology and protocols: System Commands

This connector requires advanced privileges on the managed host for the command below:

• /opt/lsi/bin/sas2ircu

This connector therefore needs to run as root or you need to configure a privilege-escalation mechanism like sudo on the managed host to allow the monitoring account to run the command listed above.

Sample of /etc/sudoers to allow the above command to be run as root by the patrol account:

patrol ALL=(root) NOPASSWD: /opt/lsi/bin/sas2ircu

Connector Activation Criteria

The LSI sas2ircu Managed Raid Controllers connector will be automatically activated, and its status will be reported as OK if all of the criteria below are met:

• The command below succeeds on the monitored host
  • Command: /opt/lsi/bin/sas2ircu
  • Output contains: SAS2IRCU: No command specified (regex)
• The command below succeeds on the monitored host
  • Command: /opt/lsi/bin/sas2ircu LIST
  • Output contains: ^[0-9].*SAS.*:.*:.*: (regex)
• The command below succeeds on the monitored host
  • Command: /bin/sh %EmbeddedFile(1)%
  • Output contains: Device is a (regex)