Back to the list of connectors

H3C UniServer R4000 Series (SNMP)

Description

This connector discovers the status of an H3C Uniserver R4900 system using its out-of-band HDM2 (Hardware Device Management 2) interface, as well as various environment sensors (temperatures, fans, power supplies, etc.). Requires HDM2

Connector file name: MS_HW_H3CUniserver.hdf

Target

Typical platform: H3C Uniserver R4000 Series

Operating system: Out-of-Band

Prerequisites

Leverages: HDM2's SNMP Agent

Technology and protocols: SNMP

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The H3C UniServer R4000 Series (SNMP) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.4.1.25506.13.1.2.2.8.1 must return a value in the same subtree

Monitors

Object Type Collected Parameters Discovered Properties
Enclosure (MS_HW_ENCLOSURE)
  • Power Consumption
  • Status
  • BIOS Version
  • Model
  • Serial Number
  • Type
  • Vendor
Disk Controller (MS_HW_DISKCONTROLLER)
  • Controller Status
  • Status
  • Firmware Version
  • Model
  • Serial Number
Processor (MS_HW_CPU)
  • Status
  • Maximum Speed
  • Model
  • Vendor
Fan (MS_HW_FAN)
  • Speed
  • Speed Percent
  • Status
    Logical Disk, RAID (MS_HW_LOGICALDISK)
    • Status
    • RAID Level
    • Size
    Memory Module (MS_HW_MEMORY)
    • Status
    • Model
    • Serial Number
    • Size
    • Vendor
    Network Card, FC Port (MS_HW_NETWORK)
    • Link Speed
    • Link Status
    • Status
    • Serial Number
    • Vendor
    Physical Disk (MS_HW_PHYSICALDISK)
    • Status
    • Model
    • Serial Number
    • Size
    • Vendor
    Power Supply (MS_HW_POWERSUPPLY)
    • Status
    • Power (Nominal)
    Temperature Sensor (MS_HW_TEMPERATURE)
    • Status
    • Temperature
    • Additional Information 1
    • Alarm Threshold
    • Warning Threshold
    No results.