Back to the list of connectors

Extreme Networks (SNMP)

Connector file name: MS_HW_ExtremeNetworks.hdf

This connector supersedes:

Description

This connector discovers the enclosure and Ethernet ports of a system equipped with an MIB-2 standard SNMP Agent.

Target

Typical platform: Extreme

Operating system: Network Device

Prerequisites

Leverages: MIB-2 Standard SNMP Agent

Technology and protocols: SNMP

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The Extreme Networks (SNMP) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.4.1.1916.1 must return a value in the same subtree

Monitors

Object Type Discovered Properties Collected Parameters
Enclosure (MS_HW_ENCLOSURE)
  • Serial Number
  • Type
  • Vendor
  • Status
Fan (MS_HW_FAN)
    • Speed
    • Status
    Network Card, FC Port (MS_HW_NETWORK)
    • Device Type
    • Physical Address
    • Physical Address Type
    • Bandwidth Utilization
    • Error Percent
    • Link Speed
    • Link Status
    • Received Bytes Rate
    • Received Packets Rate
    • Status
    • Transmitted Bytes Rate
    • Transmitted Packets Rate
    Power Supply (MS_HW_POWERSUPPLY)
    • Additional Information 1
    • Power (Nominal)
    • Power Supply Type
    • Status
    Temperature Sensor (MS_HW_TEMPERATURE)
      • Status
      • Temperature
      Keywords:
      hardware hdf patrol connectors