Type
  • Troubleshooting
Description
  • This article describes how to verify the configuration and status of the HP 3PAR CIM Server of you encounter monitoring issues.
Additional Keywords
  • CIM Server, Command Line Interface, HP 3PAR, SMI-S Provider

Related Topics

Knowledge Base

Troubleshooting HP 3PAR Monitoring Issues

KB1156 - Nov 06, 2014

Description

Sentry's HP 3PAR monitoring solutions rely on the HP 3PAR embedded SMI-S Provider (also known as  HP 3PAR CIM Server) to collect hardware and performance metrics about HP 3PAR storage systems and bring them into the BMC monitoring platforms.

In some cases, the monitoring issues may be related to the HP 3PAR CIM server. This article describes how to verify the configuration and status of the HP 3PAR CIM Server. This will help you identify whether the problem is related to the CIM Server or to the monitoring solution itself.

Verifying the version of the HP 3PAR Storage Server Software

  • Logon to HP 3PAR Command Line Interface (CLI)
  • Enter the IP Address of HP 3PAR Storage System, Username and Password (Default Credentials: 3paradm / 3pardata).
  • Run the “showversion” command to check the version of the storage server software. The minimum supported version is 3.0.0

Ensuring that the HP 3PAR CIM Server is running

To verify whether the HP 3PAR CIM server is running:

  • Run the “showcim” command. The following result should appear:
    cli% showcim
    -Service- -State- --SLP-- SLPPort -HTTP-- HTTPPort -HTTPS- HTTPSPort PGVer CIMVer
    Enabled Active Enabled 427 Enabled 5988 Enabled 5989 2.5.1 2.3.1
  • Check the Service Column to know the CIM server status. If the status is “Disabled”, you will have to start CIM server.

Starting the HP 3PAR CIM Server

To start the HP 3PAR CIM Server:

  • Logon to HP 3PAR Command Line Interface (CLI)
  • Enter the IP Address of HP 3PAR Storage System, Username and Password (Default Credentials: 3paradm / 3pardata).
  • Run the “startcim” command.

Setting the properties of the HP 3PAR CIM Server

Use the command “setcim” to set the properties of the CIM server. This command can also be used to:

  • Enable or disable the HTTP and HTTPS ports of the CIM server
  • Configure the port numbers associated with HTTP and HTTPs protocols
  • Enable or disable the SLP ports.

For more information, refer to the HP 3PAR Command Line Interface Reference guide.