Back to the list of connectors

Adaptec - StorMan - RAID

Connector file name: MS_HW_AdptStorManUnix.hdf

Description

Gives information about physical disks and volumes of Adaptec SAS RAID controllers through the arcconf utility.

Target

Typical platform: Any system with Adaptec

Operating systems: Oracle Solaris, Linux

Prerequisites

Relies on: arcconf

Technology and protocols: System Commands

This connector requires advanced privileges on the managed host for the command below:

  • /[opt|usr]/StorMan/arcconf

This connector therefore needs to run as root or you need to configure a privilege-escalation mechanism like sudo on the managed host to allow the monitoring account to run the command listed above.

Sample of /etc/sudoers to allow the above command to be run as root by the patrol account:

patrol ALL=(root) NOPASSWD: /[opt|usr]/StorMan/arcconf

Connector Activation Criteria

The Adaptec - StorMan - RAID connector will be automatically activated, and its status will be reported as OK if all of the criteria below are met:

  • Operating System is Oracle Solaris or Linux
  • The command below succeeds on the monitored host
    • Command: /bin/sh %EmbeddedFile(1)%
    • Output contains: Hard drive (regex)

Monitors

Object Type Discovered Properties Collected Parameters
Disk Controller (MS_HW_DISKCONTROLLER)
  • Additional Information 1
  • Additional Information 2
  • Driver Version
  • Firmware Version
  • Model
  • Serial Number
  • Battery Status
  • Controller Status
Logical Disk, RAID (MS_HW_LOGICALDISK)
  • Additional Information 1
  • RAID Level
  • Size
  • Status
Physical Disk (MS_HW_PHYSICALDISK)
  • Additional Information 1
  • Additional Information 2
  • Additional Information 3
  • Model
  • Serial Number
  • Size
  • Vendor
  • Status
Keywords:
hardware hdf patrol connectors