Back to the list of connectors

Emulex HBAs (hbacmd)

Connector file name: MS_HW_EmulexHbacmd.hdf

This connector supersedes:

Description

This connector discovers Emulex HBAs of servers running UNIX or Linux using the hbacmd utility provided with the Emulex Drivers.

Target

Typical platform: Any system with Emulex

Operating systems: Linux, Oracle Solaris

Prerequisites

Relies on: Emulex's hbacmd utility

Technology and protocols: System Commands

This connector requires advanced privileges on the managed host for the command below:

  • hbacmd

This connector therefore needs to run as root or you need to configure a privilege-escalation mechanism like sudo on the managed host to allow the monitoring account to run the command listed above.

Sample of /etc/sudoers to allow the above command to be run as root by the patrol account:

patrol ALL=(root) NOPASSWD: hbacmd

Connector Activation Criteria

The Emulex HBAs (hbacmd) connector will be automatically activated, and its status will be reported as OK if all of the criteria below are met:

  • The command below succeeds on the monitored host
    • Command: hbacmd ListHBAs
    • Output contains: Port WWN (regex)

Monitors

Object Type Discovered Properties Collected Parameters
Network Card, FC Port (MS_HW_NETWORK)
  • Bandwidth
  • Device Type
  • Model
  • Physical Address
  • Physical Address Type
  • Vendor
  • Bandwidth Utilization
  • Error Percent
  • Link Speed
  • Link Status
  • Received Bytes Rate
  • Received Packets Rate
  • Status
  • Transmitted Bytes Rate
  • Transmitted Packets Rate
Keywords:
hardware hdf patrol connectors