Back to the list of connectors

HP-UX - sasmgr Disk Controllers

Connector file name: MS_HW_HPUXSasMgr.hdf

This connector is superseded by:

Description

Provides hardware SAS RAID disks status information on HP-UX systems. Requires root privileges.

Target

Typical platforms: HP 9000, HP Integrity, HP SuperDome

Operating system: HP-UX

Prerequisites

Relies on: HP-UX system commands (sasmgr, ioscan etc.)

Technology and protocols: System Commands

This connector requires advanced privileges on the managed host for the command below:

  • /opt/sas/bin/sasmgr

This connector therefore needs to run as root or you need to configure a privilege-escalation mechanism like sudo on the managed host to allow the monitoring account to run the command listed above.

Sample of /etc/sudoers to allow the above command to be run as root by the patrol account:

patrol ALL=(root) NOPASSWD: /opt/sas/bin/sasmgr

Connector Activation Criteria

The HP-UX - sasmgr Disk Controllers connector will be automatically activated, and its status will be reported as OK if all of the criteria below are met:

  • Operating System is HP-UX
  • The command below succeeds on the monitored host
    • Command: /bin/ls /opt/sas/bin/sasmgr
    • Output contains: sasmgr$ (regex)
  • The command below succeeds on the monitored host
    • Command: /bin/sh %EmbeddedFile(1)%
    • Output contains: Info for PHY ID (regex)

Monitors

Object Type Discovered Properties Collected Parameters
Disk Controller (MS_HW_DISKCONTROLLER)
  • Firmware Version
  • Model
  • Vendor
  • Controller Status
Logical Disk, RAID (MS_HW_LOGICALDISK)
  • RAID Level
  • Size
  • Status
Physical Disk (MS_HW_PHYSICALDISK)
    • Status
    Keywords:
    hardware hdf patrol connectors