Back to the list of connectors

NetApp Filer (REST)

Connector file name: MS_HW_NetAppREST.hdf


This connector discovers the enclosure and the disks of NetApp disk arrays (filer) as well as the various environment sensors (temperatures, fans, power supplies, etc.). It relies on the REST API protocol.


Typical platform: NetApp

Operating system: Storage System


Relies on: NetApp REST API

Technology and protocols: HTTP/REST

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The NetApp Filer (REST) connector will be automatically activated, and its status will be reported as OK if all of the criteria below are met:

  • The HTTP Request below to the managed host succeeds:
    • POST /servlets/netapp.servlets.admin.XMLrequest_filer
    • Request Body:
    • The response body contains: NetApp (regex)


    Object Type Discovered Properties Collected Parameters
    Enclosure (MS_HW_ENCLOSURE)
    • Additional Information 1
    • Firmware Version
    • Model
    • Serial Number
    • Type
    • Vendor
    • Status
    Disk Controller (MS_HW_DISKCONTROLLER)
      • Controller Status
      Battery (MS_HW_BATTERY)
        • Status
        Fan (MS_HW_FAN)
          • Status
          Logical Disk, RAID (MS_HW_LOGICALDISK)
          • RAID Level
          • Status
          Network Card, FC Port (MS_HW_NETWORK)
          • Device Type
          • Physical Address
          • Physical Address Type
          • Link Speed
          • Link Status
          • Status
          Physical Disk (MS_HW_PHYSICALDISK)
          • Additional Information 1
          • Model
          • Serial Number
          • Size
          • Type
          • Status
          Power Supply (MS_HW_POWERSUPPLY)
            • Status
            Temperature Sensor (MS_HW_TEMPERATURE)
              • Status
              Voltage Sensor (MS_HW_VOLTAGE)
                • Status
              hardware hdf patrol connectors