Back to the list of connectors

NetApp 7-Mode Filer (REST)

Connector file name: MS_HW_NetAppREST7Mode.hdf

This connector is superseded by:

Description

This connector discovers the enclosure and the disks of NetApp disk arrays (filer) as well as the various environment sensors (temperatures, fans, power supplies, etc.). It relies on the REST API protocol.

Target

Typical platform: NetApp

Operating system: Storage System

Prerequisites

Relies on: NetApp REST API

Technology and protocols: HTTP/REST

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The NetApp 7-Mode Filer (REST) connector will be automatically activated, and its status will be reported as OK if all of the criteria below are met:

  • The HTTP Request below to the managed host succeeds:
    • POST /servlets/netapp.servlets.admin.XMLrequest_filer
    • Request Body:
    • The response body contains: partner-system-id (regex)

    Monitors

    Object Type Discovered Properties Collected Parameters
    Enclosure (MS_HW_ENCLOSURE)
    • Model
    • Serial Number
    • Type
    • Vendor
    • Status
    Fan (MS_HW_FAN)
      • Status
      Logical Disk, RAID (MS_HW_LOGICALDISK)
      • Size
      • Status
      Network Card, FC Port (MS_HW_NETWORK)
      • Device Type
      • Physical Address
      • Physical Address Type
      • Link Speed
      • Link Status
      • Status
      Other Device (MS_HW_OTHERDEVICE)
        • Status
        Physical Disk (MS_HW_PHYSICALDISK)
        • Additional Information 1
        • Firmware Version
        • Model
        • Serial Number
        • Size
        • Type
        • Vendor
        • Status
        Power Supply (MS_HW_POWERSUPPLY)
        • Additional Information 1
        • Status
        Temperature Sensor (MS_HW_TEMPERATURE)
          • Status
        Keywords:
        hardware hdf patrol connectors