Back to the list of connectors
EMC Navisphere CLI (LDAP User)
Connector file name: MS_HW_EMCNavisphereCLILDAP.hdf
This connector is superseded by:
This connector supersedes:
Description
This connector provides hardware monitoring through EMC Navisphere CLI (naviseccli). The naviseccli must be installed on the system where the agent is running. This connector uses naviseccli to connect to the EMC VNX controller as an "LDAP User", i.e. with "Scope 2".
Target
Typical platforms: EMC CLARiiON, EMC VNX
Operating system: Storage System
Prerequisites
Leverages: EMC naviseccli utility
Technology and protocols: System Commands
Connector Activation Criteria
The EMC Navisphere CLI (LDAP User) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:
- The command below succeeds on the agent host
- Command:
naviseccli -help
- Output contains:
Navisphere
(regex)
- Command:
- The command below succeeds on the agent host
- Command:
naviseccli -User %{USERNAME} -Password %{PASSWORD} -Address %{HOSTNAME} -Scope 2 getagent
- Output contains:
Agent Rev:
(regex)
- Command:
Monitors
Object Type | Discovered Properties | Collected Parameters |
---|---|---|
Enclosure (MS_HW_ENCLOSURE) |
|
|
Processor (MS_HW_CPU) |
|
|
Logical Disk, RAID (MS_HW_LOGICALDISK) |
|
|
Memory Module (MS_HW_MEMORY) |
|
|
Network Card, FC Port (MS_HW_NETWORK) |
|
|
Other Device (MS_HW_OTHERDEVICE) |
|
|
Physical Disk (MS_HW_PHYSICALDISK) |
|
|
Power Supply (MS_HW_POWERSUPPLY) |
|
|
hardware hdf patrol connectors