Back to the list of connectors

Fibre Alliance SNMP Agent (Switches)

Connector file name: MS_HW_FibreAllianceSwitch.hdf

This connector is superseded by:

Description

This connector discovers the enclosure and fiber-channel ports of SAN switches as well as the various environment sensors (temperatures, fans, power supplies, etc.). It relies on the SNMP protocol and supports the Fibre Alliance MIB (FCMGMT-MIB).

Target

Typical platform: Any SAN switch

Operating system: Storage System

Prerequisites

Leverages: Fibre Alliance SNMP Agent (FCMGMT-MIB)

Technology and protocols: SNMP

Connector Activation Criteria

The Fibre Alliance SNMP Agent (Switches) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.3.94.1.6.1.3 must return a value in the same subtree and contains \(^4$\)\|\(^14$\) (regex)

Monitors

Object Type Discovered Properties Collected Parameters
Enclosure (MS_HW_ENCLOSURE)
  • Model
  • Serial Number
  • Type
  • Vendor
    Fan (MS_HW_FAN)
    • Fan Type/Location
    • Status
    Network Card, FC Port (MS_HW_NETWORK)
    • Bandwidth
    • Device Type
    • Physical Address
    • Physical Address Type
    • Remote Physical Address
    • Remote Physical Address Type
    • Serial Number
    • Vendor
    • Bandwidth Utilization
    • Duplex Mode
    • Error Percent
    • Link Speed
    • Link Status
    • Received Bytes Rate
    • Received Packets Rate
    • Status
    • Transmitted Bytes Rate
    • Transmitted Packets Rate
    Power Supply (MS_HW_POWERSUPPLY)
    • Fan Type/Location
    • Status
    Temperature Sensor (MS_HW_TEMPERATURE)
    • Sensor Type/Location
    • Status
    Keywords:
    hardware hdf patrol connectors