Back to the list of connectors

HP BladeSystem (SSH)

Connector file name: MS_HW_HPBladeTelnet.hdf

This connector supersedes:

Description

This connector provides hardware monitoring for the HP BladeSystem racks through the Onboard Administrator.

Target

Typical platform: HP BladeSystem

Operating system: Out-of-Band

Prerequisites

Relies on: HP BladeSystem Onboard Administrator

Technology and protocols: SSH

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The HP BladeSystem (SSH) connector will be automatically activated, and its status will be reported as OK if all of the criteria below are met:

  • SSH is enabled on the monitored host
  • The monitored host must send >
  • The connector sends quit[Return]
  • The captured output contains HP.* BladeSystem Onboard Administrator (regex)

Monitors

Object Type Discovered Properties Collected Parameters
Enclosure (MS_HW_ENCLOSURE)
  • Model
  • Serial Number
  • Type
  • Power Consumption
  • Status
Blade (MS_HW_BLADE)
  • Blade Model
  • Blade Name
  • Serial Number
  • Power State
  • Status
Fan (MS_HW_FAN)
    • Speed Percent
    • Status
    Other Device (MS_HW_OTHERDEVICE)
    • Additional Label
    • Device Type
    • Status
    Power Supply (MS_HW_POWERSUPPLY)
    • Power (Nominal)
    • Status
    • Used Watts
    Temperature Sensor (MS_HW_TEMPERATURE)
    • Alarm Threshold
    • Warning Threshold
    • Status
    • Temperature
    Keywords:
    hardware hdf patrol connectors