Back to the list of connectors

IBM BladeCenter Management Module

Connector file name: MS_HW_IBMBlade.hdf

Description

This connector provides hardware monitoring of the IBM BladeCenter chassis through the IBM BladeCenter Management Module (SNMP-based). Needs to run remotely.

Target

Typical platform: IBM BladeCenter

Operating system: Out-of-Band

Prerequisites

Leverages: IBM BladeCenter Management Module

Technology and protocols: SNMP

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The IBM BladeCenter Management Module connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.4.1.2.3.51.2.2.1.1.2 must return a value in the same subtree

Monitors

Object Type Discovered Properties Collected Parameters
Enclosure (MS_HW_ENCLOSURE)
  • Additional Information 1
  • Additional Information 2
  • Model
  • Serial Number
  • Type
  • Vendor
  • Power Consumption
Blade (MS_HW_BLADE)
  • Additional Information 2
  • Additional Information 3
  • Blade Model
  • Blade Name
  • Serial Number
  • Power State
  • Status
Fan (MS_HW_FAN)
  • Speed Percent Warning Threshold
  • Speed Percent
  • Status
Other Device (MS_HW_OTHERDEVICE)
  • Additional Information 1
  • Additional Information 2
  • Additional Information 3
  • Device Type
  • Status
Power Supply (MS_HW_POWERSUPPLY)
  • Additional Information 1
  • Power Supply Type
  • Status
Temperature Sensor (MS_HW_TEMPERATURE)
  • Alarm Threshold
  • Warning Threshold
  • Status
  • Temperature
Voltage Sensor (MS_HW_VOLTAGE)
  • Lower Threshold
  • Upper Threshold
  • Voltage Type
  • Voltage
Keywords:
hardware hdf patrol connectors