Back to the list of connectors

IBM FlashSystem 900

Connector file name: MS_HW_IBMFlash900.hdf

Description

This connector discovers the enclosure(s) and the disks of IBM FlashSystem 900s as well as the various environment sensors (temperatures, fans, power supplies). It relies on the SNMP protocol.

Target

Typical platform: IBM FlashSystem

Operating system: Storage System

Prerequisites

Leverages: IBM FlashSystem 900 SNMP Agent

Technology and protocols: SNMP

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The IBM FlashSystem 900 connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.4.1.2.6.255.1.1.1 must return a value in the same subtree

Monitors

Object Type Discovered Properties Collected Parameters
Enclosure (MS_HW_ENCLOSURE)
  • Firmware Version
  • Model
  • Type
    Blade (MS_HW_BLADE)
    • Additional Information 1
    • Blade Model
    • Status
    Fan (MS_HW_FAN)
    • Speed Percent Warning Threshold
    • Warning Threshold
    • Speed
    • Speed Percent
    Logical Disk, RAID (MS_HW_LOGICALDISK)
    • RAID Level
    • Size
    • Status
    Network Card, FC Port (MS_HW_NETWORK)
    • Physical Address
    • Physical Address Type
    • Link Speed
    • Link Status
    Physical Disk (MS_HW_PHYSICALDISK)
    • Additional Information 1
    • Size
    • Status
    Power Supply (MS_HW_POWERSUPPLY)
      • Status
      Keywords:
      hardware hdf patrol connectors