Back to the list of connectors

NetApp 7-Mode Filer (REST)

Connector file name: MS_HW_NetAppREST7Mode.hdf

This connector is superseded by:

Description

This connector discovers the enclosure and the disks of NetApp disk arrays (filer) as well as the various environment sensors (temperatures, fans, power supplies, etc.). It relies on the REST API protocol.

Target

Typical platform: NetApp

Operating system: Storage System

Prerequisites

Leverages: NetApp REST API

Technology and protocols: HTTP/REST

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The NetApp 7-Mode Filer (REST) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • The HTTP Request below to the managed host succeeds:
    • POST /servlets/netapp.servlets.admin.XMLrequest_filer
    • Request Body:
    • The response body contains: partner-system-id (regex)

Monitors

Object Type Discovered Properties Collected Parameters
Enclosure (MS_HW_ENCLOSURE)
  • Model
  • Serial Number
  • Type
  • Vendor
  • Status
Fan (MS_HW_FAN)
    • Status
    Logical Disk, RAID (MS_HW_LOGICALDISK)
    • Size
    • Status
    Network Card, FC Port (MS_HW_NETWORK)
    • Device Type
    • Physical Address
    • Physical Address Type
    • Link Speed
    • Link Status
    • Status
    Other Device (MS_HW_OTHERDEVICE)
      • Status
      Physical Disk (MS_HW_PHYSICALDISK)
      • Additional Information 1
      • Firmware Version
      • Model
      • Serial Number
      • Size
      • Type
      • Vendor
      • Status
      Power Supply (MS_HW_POWERSUPPLY)
      • Additional Information 1
      • Status
      Temperature Sensor (MS_HW_TEMPERATURE)
        • Status
        Keywords:
        hardware hdf patrol connectors