Back to the list of connectors

Cisco UCS B-Series (SNMP)

Description

This connector enables hardware monitoring for the Cisco B-Series Servers via the SNMP agent of the UCS Manager. It does not connect to the blades themselves.

Connector file name: MS_HW_CiscoUCSBladeSNMP.hdf

This connector is superseded by:

Target

Typical platform: Cisco B-Series Servers

Operating system: Out-of-Band

Prerequisites

Leverages: Cisco UCS Manager SNMP Agent

Technology and protocols: SNMP

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The Cisco UCS B-Series (SNMP) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.4.1.9.9.719.1.9.2.1.2 must return a value in the same subtree

Monitors

Object Type Collected Parameters Discovered Properties
Enclosure (MS_HW_ENCLOSURE)
  • Status
  • Model
  • Serial Number
  • Vendor
Disk Controller (MS_HW_DISKCONTROLLER)
  • Controller Status
  • Status
  • Firmware Version
  • Model
  • Serial Number
  • Vendor
Processor (MS_HW_CPU)
  • Status
  • Maximum Speed
  • Model
  • Vendor
Memory Module (MS_HW_MEMORY)
  • Status
  • Additional Information 1
  • Additional Information 2
  • Serial Number
  • Size
Physical Disk (MS_HW_PHYSICALDISK)
  • Status
  • Model
  • Size
  • Vendor
Keywords:
hardware hdf patrol connectors
No results.