Back to the list of connectors

NetApp Filer (REST)

Description

This connector discovers the enclosure and the disks of NetApp disk arrays (filer) in C-mode as well as various environment sensors (temperatures, fans, power supplies, etc.). It relies on the REST API protocol.

Connector file name: MS_HW_NetAppREST.hdf

This connector is superseded by:

Target

Typical platform: NetApp

Operating system: Storage System

Prerequisites

Leverages: NetApp REST API

Technology and protocols: HTTP/REST

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The NetApp Filer (REST) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • The HTTP Request below to the managed host succeeds:
    • POST /servlets/netapp.servlets.admin.XMLrequest_filer
    • Request Body:
    • The response body contains: NetApp (regex)

Monitors

Object Type Collected Parameters Discovered Properties
Enclosure (MS_HW_ENCLOSURE)
  • Status
  • Additional Information 1
  • Model
  • Serial Number
  • Type
  • Vendor
Disk Controller (MS_HW_DISKCONTROLLER)
  • Controller Status
  • Status
    Battery (MS_HW_BATTERY)
    • Status
      Fan (MS_HW_FAN)
      • Status
        Logical Disk, RAID (MS_HW_LOGICALDISK)
        • Status
        • RAID Level
        Network Card, FC Port (MS_HW_NETWORK)
        • Link Speed
        • Link Status
        • Status
        • Device Type
        • Physical Address
        • Physical Address Type
        Physical Disk (MS_HW_PHYSICALDISK)
        • Status
        • Additional Information 1
        • Additional Information 2
        • Model
        • Serial Number
        • Size
        Power Supply (MS_HW_POWERSUPPLY)
        • Status
          Temperature Sensor (MS_HW_TEMPERATURE)
          • Status
            Voltage Sensor (MS_HW_VOLTAGE)
            • Status
              Keywords:
              hardware hdf patrol connectors
              No results.