Back to the list of connectors

IBM VIO Server

Description

This connector provides hardware status information on IBM VIO systems (processors, memory modules, network interfaces, HBAs, physical disks) on IBM VIO systems.

Connector file name: MS_HW_IBMVIOS.hdf

This connector supersedes:

Target

Typical platform: IBM POWER

Operating system: IBM AIX

Prerequisites

Leverages: IBM AIX system commands through the IOS interface (lsdev, entstat, etc.)

Technology and protocols: System Commands

Connector Activation Criteria

The IBM VIO Server connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • Operating System is IBM AIX
  • The command below succeeds on the monitored host
    • Command: ioscli uname -a
    • Output contains: AIX (regex)

Monitors

Object Type Collected Parameters Discovered Properties
Enclosure (MS_HW_ENCLOSURE)
  • Additional Information 1
  • Additional Information 2
  • Additional Information 3
  • Model
  • Serial Number
  • Type
  • Vendor
Disk Controller (MS_HW_DISKCONTROLLER)
  • Controller Status
  • Status
  • Model
Processor (MS_HW_CPU)
  • Status
    LUN (MS_HW_LUN)
    • Available Path Count
      Memory Module (MS_HW_MEMORY)
      • Error Count
      • Status
      • Serial Number
      • Size
      Network Card, FC Port (MS_HW_NETWORK)
      • Bandwidth Utilization
      • Duplex Mode
      • Error Count
      • Error Percent
      • Link Speed
      • Link Status
      • Received Bytes Rate
      • Received Packets Rate
      • Status
      • Transmitted Bytes Rate
      • Transmitted Packets Rate
      • Bandwidth
      • Device Type
      • Physical Address
      • Physical Address Type
      • Serial Number
      Physical Disk (MS_HW_PHYSICALDISK)
      • Error Count
      • Serial Number
      • Size
      • Vendor
      Keywords:
      hardware hdf patrol connectors
      No results.